Rough-country 324S User Manual download pdf (Page 16)

22. Also install washer on bottom of shock to the outside of truck. See Photo 19. Use 21mm to tighten.

23. Pull down and straighten brake line. Take care not to kink the brake line.

24. Install sway bar links & brake line brackets on the frame with the supplied 12Mm x 65mm bolts, washers and nut.

See Photo 20.

25. Install stock brake line mount on the bracket using the supplied 5/16” x 3/4” bolt, washers and nut. See Photo 21.

Use a 18mm and 19 mm to tighten sway bar link bolts and 13 mm for brake line bolts.

26. Install track bar into bracket with stock hardware. You may have to do this with truck on the ground. Tighten upper

bolt using 22mm wrench and lower with 21mm wrench.

27. With WD-40 or alcohol adjust the rubber insulator on ABS wire so that it will fit back into clip on brake line. See

Photo 22.

28. If not removed previously, Cut zip tie for axle vent tube and install new zip tie and vent tube on lower part of frame.

See Photo 23 & 24.

29. Reinstall fender wells using 8mm socket.

30. Check to make sure all fasteners are tight.

PHOTO 19

PHOTO 20

PHOTO 21 PHOTO 22

PHOTO 23 PHOTO 24

INSTALL WASHER TO PREVENT RUBBING INSTALL LINK AND BRAKE BRACKET

TIGHTEN HARDWARE SPRAY LINE AND MOVE RUBBER MOUNT

CUT ZIP TIE AND MOVE DIFF VENT HOSE ZIP TIE VENT HOSE IN PLACE

1 2 ... 11 12 13 14 15 16 17 18 19 20

No comments

Rough-country 324S User Manual Page 16