Rough-country 324S User Manual download pdf (Page 4)

1. Chock rear wheels of the vehicle and raise the front of the vehicle using a floor jack.

2. Support the vehicle with jack stands.

3. Remove wheel using 22mm socket.

4. Remove tie-rod end nut using 21mm as shown in Photo 1.

5. Strike with hammer to dislodge the tie rod from the knuckle. See Photo 2.

6. Remove brake caliper using 21mm wrench. See Photo 3. Secure out of way and remove rotor.

7. Remove ABS wire from hub using 5mm allen wrench, unclip ABS wire from knuckle also. See Photo 4.

8. Remove axle nut using 35mm socket. See Photo 5.

9. Remove knuckle using 21mm wrench for top ball joint and 24mm wrench for lower ball joint. Strike with hammer as

shown to dislodge the ball joints. Upper Joint shown in Photo 6.

10. Remove the stock knuckle from the truck. Take care not to allow the shaft to over extend

INSTALLATION INSTRUCTIONS

PHOTO 1

PHOTO 2

PHOTO 3 PHOTO 4

PHOTO 5

PHOTO 6

REMOVE THE TIE ROD STRIKE WITH HAMMER TO DISLODGE

REMOVE THE CALIPER

REMOVE ABS WIRE

REMOVE THE AXLE NUT STRIKE AS SHOWN TO DISLODGE

1 2 3 4 5 6 7 8 9 ... 19 20

No comments

Rough-country 324S User Manual Page 4