Rough-country 324S User Manual download pdf (Page 11)

49. Notch a section of the stock mount to remove the brake line as shown in Photo 43 and remove line from housing.

Straighten bends in hard metal lines making sure to not kink lines.

50. Install new brake line bracket onto brake line using supplied 5/16” x 3/4” bolts, washers and nuts. See Photo 44.

51. Then attach bracket to frame using stock bolt in lower hole and new supplied 3/8” x 1” bolts, washers and nuts. See

Photo 45. Use a 13mm wrench to tighten stock bolt and lower brake line bolt then use a 14mm on top 3/8” bolt.

52. Remove bearing assembly from the stock knuckle using 18mm socket. See Photo 46.

53. Install bearing into new knuckle using stock bolts and a thread locking compound. See Photo 47.

54. Install new knuckle onto truck using a 24 and 12mm wrench for lower ball joint. See Photo 48.

PHOTO 43 PHOTO 44

PHOTO 45 PHOTO 46

PHOTO 47

PHOTO 48

CUT BRAKE LINE MOUNT INSTALL LINE ON NEW BRACKET

INSTALL HARDWARE TO SECURE LINE REMOVE THE BEARING FROM KNUCKLE

INSTALL THE BEARING ON NEW KNUCKLE INSTALL KNUCKLE ON LOWER BALL JOINT

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

No comments

Rough-country 324S User Manual Page 11