Rough-country 324S User Manual download pdf (Page 12)

55. Slide the axle in the bearing assembly and install the knuckle on the upper ball joint using a 21mm and 10mm

wrench. See Photo 49.

56. Tighten the axle nut using a 35mm socket. See Photo 50.

57. Unclip ABS wire from upper control arm and install wire back into bearing assembly using 5mm allen wrench. See

Photo 51.

58. Using WD-40 move the rubber insulator into right spot and clip back into upper control arm. See Photo 52.

59. Install rotor and brake caliper. Use a 21mm socket to tighten caliper.

60. Install tie rod into knuckle using 21mm wrench. See Photo 53.

61. Using a T30 bit remove ABS wire bracket from old knuckle and install on new one. Reinstall the ABS wire on the

mount. See Photo 54.

62. Repeat steps 38-57 for opposite side.

63. Install tires and wheels.

64. Remove the jack stands and lower the vehicle to the ground.

65. Tighten lower control arm hardware using a 24mm socket / wrench

PHOTO 49

PHOTO 50

PHOTO 51 PHOTO 52

PHOTO 54

PHOTO 53

INSTALL KNUCKLE ON UPPER BALL JOINT

INSTALL AXLE NUT

REINSTALL THE ABS WIRE SPRAY LINE AND SLIDE RUBBER MOUNT

TIGHTEN TIE ROD HARDWARE

INSTALL ABS WIRE BRACKET

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Rough-country 324S User Manual Page 12