Rough-country RC714 User Manual download pdf (Page 8)

1. Loosen the 8 bolts holding the bed on using a 18mm socket. See Photo 1. Remove the six rear bolts on bed leav-

ing the front bolts near cab in but loose. Lift the rear of bed up just enough to place one of the body puck between

frame and bed. This is done so rear bumper can be removed. See Photo 2.

2. Unplug the rear bumper wiring from the junction box on the frame and unplug the 7 way connector from bumper.

See Photo 3.

3. With the license plate remove reach be hide the bumper and remove the two bolts using a 13mm wrench. One is on

the left and one on the right. Using a 15mm, 18mm and a 21mm socket remove bumper bolts. See Photo 4. ( note

bumper was remove to show better picture). Remove bumper and place on a clean surface.

4. Mark and cut the tap off the frame for the spare tire

tube. Cut straight across the top making the top flat

with no ridge. See Photo 5.

BED/REAR BUMPER INSTALLATION INSTRUCTIONS

**Note** The bumper is removed in the first three pictures to help show locations for the bolts and electrical

plugs. The bumper is not removed until step 3.

PHOTO 3 PHOTO 4

PHOTO 2

PHOTO 1

PHOTO 5

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Rough-country RC714 User Manual Page 8