Rough-country RC714 User Manual download pdf (Page 5)

18. Once the bushing is out knock the two studs out using a hammer and vise. See Photo 19. Replace the two stud with

the supplied 3/8” x 2.25” bolts, washers, and nuts. Install cab body puck on body bushing and place on truck. See

Photo 20.

19. Install the 1.25” x 3” round body puck onto of rear cab body bushing. Use a 14mm socket and wrench to tighten new

bolt. Lower body onto body bushing and install body bolts but do not tighten at this time. Install a new rear cab bolt

14mm x 140mm. See Photo 21. Repeat step for other side. Make sure the wiring does not get pinch under the

flag bolt on the two front body mounts while installing. Once all body puck are in tighten all bolts using 19mm

for front body bolts 21mm for middle bolts and 22mm for rear cab bolts.

20. Install emergency brake line bracket using the supplied 1/2” x 1” bolt, washer, and nut. Use a 19mm socket and

wrench to tighten. See Photo 22. Reconnect the emergency brake cable. Take a 1/4 off inch off the original meas-

urement taken adjust the parking brake cable to around 2.25” from the back of the nut to the end of the threads.

21. Reinstall ground wires and O2 sensor clip back onto frame using 10mm socket. Ground wire on passenger side

body mount be hide tire will need a clip removed to get slack in wire.

PHOTO 19

PHOTO 20

PHOTO 21 PHOTO 22

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Rough-country RC714 User Manual Page 5