Rough-country RC601 User Manual

Browse online or download User Manual for For the car Rough-country RC601. Rough Country RC601 User Manual [en]

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Thank you for choosing Rough Country for your Jeep JK needs.
Rough Country recommends a certified technician installs this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
Please read all the instructions before beginning the installation. Check the kit hardware against the parts list. Be sure
you have all the needed parts and understand where they go. Also please review the tools needed list and make sure
you have needed tools.
JEEP JK 1 1/4” 2 / 4 DOOR BODY LIFT KIT
92RC60000
KIT CONTENTS:
RC601:
12- RC Body Blocks (4 DOOR KIT)
1—Kit Bag Containing
24—3/8” x 2 1/4” Bolts
24—3/8” Nuts
48—3/8” Washers
Rear Bumper Brackets
RC600:
10- RC Body Blocks (2 DOOR KIT)
1—Kit Bag Containing
20—3/8”X 2 1/4” Bolts
20—3/8” Nuts
40—3/8” Washers
Rear Bumper Brackets
TOOLS NEEDED:
18mm Wrench
16mm Wrench
3/4” Wrench
9/16” Wrench & Socket
Phillips Screw Driver
Jack Stands
Wood Block
Hammer
2DR & 4DR BODY MOUNT LOCATIONS
4DR MODELS WILL
HAVE 12 MOUNTING
POINTS
Page view 0
1 2 3 4

Summary of Contents

Page 1

Thank you for choosing Rough Country for your Jeep JK needs. Rough Country recommends a certified technician installs this system. In addition to th

Page 2

INSTALLATION INSTRUCTIONS FOR JEEP JK 2 AND 4 DOOR BODY LIFT 1. Place Jeep on clean, dry, level surface. Installation is done one side at a time. 2

Page 3

8. After removing the stock body mounts from your vehicle, replace the nut on the stud and tighten the nut only until the stud thread and nut are eve

Page 4

POST INSTALLATION 1. Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating, mobile, fixed and heat

Comments to this Manuals

No comments