Rough-country 1064 User Manual download pdf

WJ WINCH MOUNT KIT

Thank you for choosing Rough Country for all your Off Road needs.

Rough Country recommends a certified technician install this winch plate. In addition to these instructions, professional

knowledge of disassemble/reassembly procedures as well as post installation checks must be known.

Please read instructions before beginning installation. Check the kit hardware against the kit content list. Be sure you

have all needed parts and know where they go. Also please review tools needed list and make sure you have the nec-

essary tools to install this kit.

With the addition of a winch and winch plate and due to multiple coil rates available for this model; The front of the vehi-

cle may require an additional 3/4” of lift to level the vehicle. For this purpose; Rough Country offers a 3/4” front spacer,

Part # 1060.

92106400

Tools Needed:

• 3/8” Socket

• 18mm Socket / Wrench

• Tape Measure

• 3/4” Socket

• Pliers

• 9/16” Drill Bit

• Drill Motor.

• Marker

• Saw

Kit Contents:

1064 Containing:

1-Driver Side Brace

1-Pass Side Brace

1-Driver Side Frame Bracket

1-Pass Side Frame Bracket

1-Winch Plate

1064Bag2 Containing:

12-1/2” X 1 1/2” Bolts

12-1/2” Flat Washers

6-Plastic Retainers

Optional D-ring Kit Available #1169

1 2 3 4 5 6

Summary of Contents

Page 1 - WJ WINCH MOUNT KIT

WJ WINCH MOUNT KIT Thank you for choosing Rough Country for all your Off Road needs. Rough Country recommends a certified technician install this w

Page 2

INSTALLATION INSTRUCTIONS 1. Remove the ( 7) screws on the top and center of the grill See Photo 1 & 2. Retain the hardware for reuse. 2. Rem

Page 3

6. Carefully remove the bumper / grill from vehicle. See Photo 7. 7. Remove the sway bar from the frame with a 18mm socket. See Photo 8. 8. Allow t

Page 4

13. Install the winch plate bracket in the two rear holes using the supplied 1/2” x 1 1/2” bolts flat washers as shown in Photo 13. Do not tighten at

Page 5 - 16 3/4”

20. Using the pin the retainer was removed from, measure 14 1/8 and 16 3/4 over and mark. See Photo 19 & 20. 21. Using a straight edge pushed to t

Page 6

POST INSTALLATION 1. Check all fasteners for proper torque. 2. Check hardware after the first 500 miles and then every 1000 miles. 25. Install the

Comments to this Manuals

No comments

Rough-country 1064 User Manual

Browse online or download User Manual for For the car Rough-country 1064. Rough Country 1064 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Rough-country 1064