Rough-country 284.20 User Manual download pdf

Thank you for choosing Rough Country for your suspension needs.

Rough Country recommends a certified technician install this system. In addition to these instructions, professional knowl-

edge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install this sys-

tem without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.

Please read instructions before beginning installation. Check the kit hardware against the parts list on the rear cover of

these instructions. Be sure you have all needed parts and know where they go. Also please review tools needed list and

make sure you have needed tools.

PRODUCT USE INFORMATION

As a general rule, the taller a vehicle is, the easier it will roll. Seat belts and shoulder harnesses should be worn at all times.

Avoid situations where a side rollover may occur.

Generally, braking performance and capability are decreased when larger/heavier tires and wheels are used. Take this into

consideration while driving. Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height over

the intended height of the Rough Country product purchased. Mixing component brands is not recommended.

Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will not be responsi-

ble for any product that is altered.

If question exist we will be happy to answer any questions concerning the design, func-

tion, and correct use of our products.

**Note** The electric power steering must be unplugged before any of the steering components are removed. Failure to do

so may cause damage to the electric power steering.

This kit is packaged as a leveling kit—raising the front 3.5” and the back 1.5”. If you desire a different look or if the vehicle

has a tool box or added weight in the rear, please consult with your sales representative about other block and u-bolt op-

tions.

This suspension system was developed using a 32 x 11.5 tire with factory wheels. Examples of tire sizes that can be used

are 285/75R17, 285/65R18, or 285/55R20. Note if wider tires are used, offset wheels will be required and trimming may be

required.

92271N2000

2014 2WD GM 1500 3.5” FRT

1.5” REAR LIFT KIT

1 2 3 4 5 6

Summary of Contents

Page 1 - 1.5” REAR LIFT KIT

Thank you for choosing Rough Country for your suspension needs. Rough Country recommends a certified technician install this system. In addition to

Page 2

TOOLS NEEDED: 18MM Wrench 17MM Wrench 15MM Wrench 21MM Wrench 11MM Wrench 10MM Wrench Floor Jack Jack stands TORQUE SPECS: Size Class 8.8

Page 3

FRONT INSTALLATION 1. Park the vehicle on a level surface and chock the rear wheels. 2. Jack up the front of the vehicle. Place jack stands under t

Page 4

10. Mark location of alignment cams on upper control arms to allow installation of new arm to same position. Using a 21mm wrench and 21mm socket, rem

Page 5

15. Reinstall the sway bar on the lower control arm using a15mm wrench. 16. Install the upper control arm / ball joint assembly onto the knuckle with

Page 6

Thank you for choosing Rough Country for your suspension needs. KIT CONTENTS Box Kit 1-Driver Side Control Arm 1-Pass Side Control Arm 2-Strut S

Comments to this Manuals

No comments

Rough-country 284.20 User Manual

Browse online or download User Manual for For the car Rough-country 284.20. Rough Country 284.20 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Rough-country 284.20