Rough-country 277.20 User Manual

Browse online or download User Manual for For the car Rough-country 277.20. Rough Country 277.20 User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Thank you for choosing Rough Country for your suspension needs.
Rough Country recommends a certified technician install this system. In addition to these instructions, professional knowl-
edge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install this sys-
tem without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
Please read instructions before beginning installation. Check the kit hardware against the parts list on the rear cover of
these instructions. Be sure you have all needed parts and know where they go. Also please review tools needed list and
make sure you have needed tools.
PRODUCT USE INFORMATION
As a general rule, the taller a vehicle is, the easier it will roll. Seat belts and shoulder harnesses should be worn at all times.
Avoid situations where a side rollover may occur.
Generally, braking performance and capability are decreased when larger/heavier tires and wheels are used. Take this into
consideration while driving. Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height over
the intended height of the Rough Country product purchased. Mixing component brands is not recommended.
Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will not be responsi-
ble for any product that is altered.
If question exist we will be happy to answer any questions concerning the design, func-
tion, and correct use of our products.
This kit is packaged as a leveling kitraising the front 3.5 and the back 1.5. If you desire a different look or if the vehicle
has a tool box or added weight in the rear, please consult with your sales representative about other block and u-bolt op-
tions.
This suspension system was developed using a 32 x 11.5 tire with factory wheels. Examples of tire sizes that can be used
are 285/75R17, 285/65R18, or 285/55R20. Note if wider tires are used, offset wheels will be required and trimming may be
921268N200
07 & UP 2WD GM 1500 3.5” FRT
1.5” REAR LIFT KIT
TOOLS NEEDED:
18MM Wrench
17MM Wrench
15MM Wrench
21MM Wrench
11MM Wrench
9/16 Wrench
Floor Jack
Jack stands
TORQUE SPECS:
Size Class 8.8 Class 10.9
10MM 32ft/lbs 45ft/lbs
12MM 55ft/lbs 75ft/lbs
14MM 85ft/lbs 120ft/lbs
NOTICE TO DEALER AND VEHICLE OWNER
Any vehicle equipped with any Rough Country product should have a Warning to Driver decal installed on the inside of the
windshield or on the vehicles dash. The decal should act as a constant reminder for whoever is operating the vehicle of its
unique handling characteristics.
INSTALLING DEALER - it is your responsibility to install the warning decal and forward these installation instructions on to
the vehicle owner for review. These instructions should be kept in the vehicle for its service life.
Page view 0
1 2 3 4

Summary of Contents

Page 1 - 1.5” REAR LIFT KIT

Thank you for choosing Rough Country for your suspension needs. Rough Country recommends a certified technician install this system. In addition to

Page 2

FRONT INSTALLATION 1. Park the vehicle on a level surface and chock the rear wheels. 2. Jack up the front of the vehicle. Place jack stands under t

Page 3

10. Cut the bump stop from the upper control arm mount on the passenger and driver side as shown in Photo 7 using a reciprocating saw. Passenger side

Page 4

REAR INSTALLATION 1. Chock the front wheels. 2. Place a floor jack under the differential and jack up the rear of the vehicle. 3. Place jack stands

Comments to this Manuals

No comments