Rough-country 1085 User Manual

Browse online or download User Manual for For the car Rough-country 1085. Rough Country 1085 User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
97– 06 TJ FRONT ADJ TRACK BAR KIT
INSTALLATION INSTRUCTIONS
1. Remove the track rod from the axle and from the frame using a 15mm (axle) & 18mm wrench (frame).
2. Install the track rod bracket as shown with the 1/2” x 1 3/4”, washer & nut in the stock track rod mount. Make
sure the bracket is flat against the frame. Snug but do not fully tighten at this time. Photo 1.
3. Using the bracket as a guide, mark and drill the two side holes through the inner and outer frame as shown
in Photo 2 using a 17/32” drill bit. Make sure to keep the drill level when drilling.
92108500
Thank you for choosing Rough Country for your Jeep off road needs.
Please read all the instructions before beginning the installation.
PRODUCT USE INFORMATION
We will be happy to answer any questions regarding our products by calling us @ 800-222-7023. Rough Country
will not be responsible for any product that is altered. This kit is for use with vehicles lifted 2 1/2” -8” of lift.
This kit will not work on a non lifted vehicle.
KIT CONTENTS
1-TRACK ROD BRACKET
1-POLY BAG CONTAINING
1-1/2” X 1 3/4” BOLT
2-1/2” X 4” BOLT
3-1/2” NUT
7-1/2 WASHER
2-BUSHINGS
1-7/16” SLEEVE
1-HEIM END
2-HEIM SPACERS
2-7/16” X 2 3/4” BOLT
2-7/16” NUT
4-7/16” WASHERS
2-FRAME CRUSH SLEEVES
1-3/4” JAM NUT
1-ADJ TRACK ROD BODY & END
TOOLS NEEDED
17/32 DRILL BIT
29/32” DRILL BIT
DRILL MOTOR
18MM SOCKET
15MM SOCKET
5/8” WRENCH/SOCKET
1 1/8” Wrench
PHOTO 1 PHOTO 2
PLEASE NOTE A EXTENDED PITMAN ARM IS RECOMMENDED WHEN INSTALLING THIS KIT TO
ENSURE THE VEHICLE DOES NOT DEVELOP BUMPSTEER. PART #6605 IS AVAILABLE FROM YOUR
ROUGH COUNTRY DEALER. PLEASE CALL 1-800-222-7023 FOR DETAILS
Page view 0
1 2

Summary of Contents

Page 1

97– 06 TJ FRONT ADJ TRACK BAR KIT INSTALLATION INSTRUCTIONS 1. Remove the track rod from the axle and from the frame using a 15mm (axle) & 18mm w

Page 2

POST INSTALLATION 1. Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating, mobile, fixed and heat

Comments to this Manuals

No comments