Rough-country 375 User Manual download pdf

Rough Country recommends this system be installed by a certified technician. In addition to these instructions, profes-

sional knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to

install this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehi-

cle.

Please read instructions before beginning installation. Check the kit hardware against the Kit Contents List. Be sure you

have all needed parts and know where they go.

PRODUCT USE INFORMATION

Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height over the intended height of the

Rough Country product purchased. Mixing component brands is not recommended. Rough Country will not be responsi-

ble for any product that is altered.

If question exist, please call us @1-800-222-7023. We will be happy to answer any questions concerning the design,

function, and correct use of our products.

2013 Dodge 3500 2.5” Leveling Kit

Tools Needed:

10mm Socket

13mm Socket

21mm Wrench / Socket

9/16” Socket

7/8” Socket

92375000

INSTALLATION INSTRUCTIONS

1. Chock the rear wheels. Jack up the front of the vehicle and place jack stands directly behind the lower control arm

mounts on the frame rails. After the vehicle is on jack stands, position a floor jack underneath the front differential.

This is to support the axle and to allow the front axle to droop to remove the stock coil springs. Remove the tires and

wheels with a 7/8” socket.

2. Remove the sway bar link with a 10mm socket and a

21mm wrench. See Photo 1.

3. Remove the lower shock bolt using a 21mm socket. Note

this bolt has a flag nut. Retain hardware for reuse.

4. Remove the push pin wire tie from the box on the axle for

movement to remove the coil.

5. Remove the brake line from the mount on top of the ra-

dius arm using a 13mm socket.

Kit Contents:

2– Coil Spring Spacers

1-375bag:

2-3/8” x 3 1/4” Bolts

2-3/8” Flat Washer

2-Flag Nuts

Photo 1

1 2

Summary of Contents

Page 1

Rough Country recommends this system be installed by a certified technician. In addition to these instructions, profes-sional knowledge of disassem

Page 2

7. Lower the axle with a jack and remove the factory coil springs. Push on the alignment pin on the isolator and remove from truck. See Photo 1. 8.

Comments to this Manuals

No comments

Rough-country 375 User Manual

Browse online or download User Manual for For the car Rough-country 375. Rough Country 375 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Rough-country 375