Rough-country RC714 User Manual download pdf (Page 10)

11. Install new bumper brackets using stock hardware and a 40 torx to tighten. See Photo 12.

12. Reassemble rear bumper

13. Remove the body puck from the rear of bed that was place to help remove the bumper and install the bed bolts on

one side of the truck to hold the bed in place while installing bed pucks. Hand tighten bolts. Remove the bolt from

front of bed that was left loose earlier.

14. Lift one side of the bed at a time and install the five 1 1/4 body pucks. See Photo 13. Use the supplied 12mm bolts,

washers. Repeat this step for other side. Use a 19mm socket to tighten bed bolts

15. Install rear bumper step support bracket using the stock hardware. Use a 13mm socket to tighten. See Photo 14.

16. Reinstall rear bumper using stock hardware. See Photo 15. Make sure spare tire tube go back in bumper correctly.

17. Plug in the 7 way connector and bumper wiring. Tighten bumper using a 15mm, 18mm and a 21mm sockets. Make

sure bumper is level

18. Reconnect battery

PHOTO 14

PHOTO 13 PHOTO 12

PHOTO 15

1 2 ... 5 6 7 8 9 10 11 12

No comments

Rough-country RC714 User Manual Page 10