Rough-country 1051 User Manual download pdf

JEEP JK CLASS III - 2” RECEIVER HITCH

Thank you for choosing Rough Country for all your suspension needs.

Please read instructions before beginning installation. Check the kit hardware against the kit contents shown below. Be

sure you have all needed parts and know where they go.

To install this receiver hitch you will need a 18mm wrench to remove the OEM tow hook, if equipped, and a 5/8” wrench.

92105100

INSTALLATION INSTRUCTIONS

1. For vehicles equipped with OEM Tow Hook: Remove the factory hardware securing the factory hook with a 18mm

wrench. Remove the tow hook bracket. See Figure 1. Use caution to make sure muffler is not hot.

2. Install the new Rough Country bracket in the same location as the stock bracket was removed and using the 4 sup-

plied 7/16 bolts, lock washers as shown in Figure 2. The new bracket will utilize 4 of the factory holes in the frame

as the stock bracket only used 3.Tighten hardware to 50 ft/lbs.

Figure 1

Figure 2

Removing OEM Tow Hook—required

Installing Class III Receiver Hitch

7/16” 4.5” Long Bolt (4)

RC Receiver Hitch for Jeep JK

Not Shown—7/16” Lock Washer (4)

Removing OEM Tow Hook

IMPORTANT INFORMATION:

Do not exceed 2,000 lbs factory

towing capacity of the Jeep JK

and do exceed a maximum

tongue weight of 350 lbs.

JEEP JK CLASS III - 2” RECEIVER HITCH Thank you for choosing Rough Country for all your suspension needs. Please read instructions before beginnin

No comments

Rough-country 1051 User Manual