Rough-country 658N2 User Manual

Browse online or download User Manual for For the car Rough-country 658N2. Rough Country 658N2 User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
97-06 JEEP TJ 2” FRONT / 1 1/4” REAR SPACER KIT
9265800
Tools Needed:
13mm Socket / Wrench
15mm Socket
18mm Socket / Wrench
19mm Socket / Wrench
T55 Torx Head Bit
9/16” Socket / Wrench
Thank you for choosing Rough Country for your suspension needs.
Rough Country recommends a certified technician installs this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to
install this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the
vehicle.
Please read all the instructions before beginning the installation. Check the kit hardware against the parts
list. Be sure you have all the needed parts and understand where they go. Also please review the tools needed list
and make sure you have needed tools.
PRODUCT USE INFORMATION
As a general rule, the taller a vehicle is the easier it will roll. We strongly recommend, because of rollover possibility,
that the vehicle be equipped with a functional roll-bar and cage system. Seat belts and shoulder
harnesses should be worn at all times. Avoid situations where a side rollover may occur.
Braking performance and capabilities are decreased when significantly larger/heaver tires and wheels are used. Take
this into consideration while driving. Also, speedometer recalibration is necessary when larger tires are installed.
Do not add, alter, or fabricate any factory or after-market parts which increase vehicle height over the intended height
of the Rough Country product purchased. Mixing component brands voids all warranties. Rough Country makes no
claims regarding lifting devices and excludes any and all implied claims. We will not be responsible for any product
that is altered.
This 2 ” suspension system was developed for 31x10.50x15 tire on an after market 8” wide wheel with 3.75” of back
spacing. The use of stock wheels with larger than stock tires may cause the tire to come in contact with the lower
control arm at full turn. The use of aftermarket wheels is recommended to avoid this. On models outfitted with extra
bolt-on equipment and accessories, Rough Country offers new coil spring isolator pads made from polyurethane to
boost ride height 3/4" and these may be needed to maintain a level performance look. Rough Country Hydro
shocks are also available for this application.
NOTICE TO DEALER AND VECHICLE OWNER
Any vehicle equipped with any Rough country product must have the “Warning to Driver” decal installed on the sun
visor or dash. The decal is to act as a constant reminder for whoever is operating the vehicle of its unique handling
characteristics. INSTALLING DEALER—It is your responsibility to install the warning decal and to forward these in-
stallation instructions on to the vehicle owner for review and to be kept in the vehicle for its service life.
Torque Specs:
Size Grade 5 Grade 8
5/16” 15 ft/lbs 20 ft/lbs
3/8” 30 ft/lbs 35 ft/lbs
7/16” 45 ft/lbs 60 ft/lbs
Class 8.8 Class 10.9
10MM 32ft/lbs 45ft/lbs
12MM 55ft/lbs 75ft/lbs
Page view 0
1 2 3 4

Summary of Contents

Page 1

97-06 JEEP TJ 2” FRONT / 1 1/4” REAR SPACER KIT 9265800 Tools Needed: 13mm Socket / Wrench 15mm Socket 18mm Socket / Wrench 19mm Socket / Wrench

Page 2

FRONT INSTALLATION INSTRUCTIONS 1. The front-end components are installed first. 2. Place the vehicle on a level surface. Set the parking brake

Page 3

9. Reinstall the coil spring as shown in Photo 3 with the stock spring isolator in between the stock coil and the new spacer on top. 10. Reinstall

Page 4

Thank you for purchasing a Rough Country Suspension Lift Kit. 9. Jack up the axle to lightly compress the coil springs. 10. Install the lower sho

Comments to this Manuals

No comments