Rough-country 1097 User Manual download pdf

5-5 1/2” WHEEL PATTERN 1 1/2” SPACER

Thank you for choosing Rough Country for all your suspension needs.

Professional knowledge of disassemble/reassembly procedures as well as post installation checks must be

known. Attempts to install these wheel spacers without this knowledge and expertise may jeopardize the integ-

rity and/or operating safety of the vehicle.

Please read instructions before beginning installation. Also please review tools needed list and make sure you

have needed tools.

Kit Contents:

2-1 1/2” Wheel Spacers

92109700

Tools Needed:

Torque Wrench

Floor Jack

Jack Stands

Flat Head Screwdriver

Installation Instructions

1. Chock the tires and jack up the vehicle.

2. Remove the lug nuts and remove the tire and wheel.

3. Remove the rotor retainer star washers if so

equipped using a flat head screwdriver. Removing

these will allow the wheel spacer to sit flat on the

rotor surface. These must be removed.

4. Install the wheel spacers as shown with the sup-

plied lug nuts. See Photo 1. Tighten to manufac-

turer specifications using a 19mm wrench.

5. Reinstall the tires/wheels. Tighten the lug nuts hold-

ing the wheels and tires to factory specifications.

Important note: Please make sure the lug nuts

are tightened against the wheel surface. Some

enclosed lug nuts are shorter and can create

the illusion that the wheel is tight on the spac-

ers when in fact the wheel stud is bottomed out

inside the lug nut. If this occurs a longer lug nut

must be purchased.

Photo 1

Post Installation

1. Re torque all fasteners after 500 miles. Visually inspect components and re torque fasteners during routine

vehicle service.

Page 1

5-5 1/2” WHEEL PATTERN 1 1/2” SPACER Thank you for choosing Rough Country for all your suspension needs. Professional knowledge of disassemble/reasse

No comments

Rough-country 1097 User Manual